• CH, Thank you for your feedback. I'll do the necessary changes.
    1. Reply
    2. 1+ years ago
  • Letter sizing The minimum letter size should probably not be less than 1 inch (2.5cm) and preferably 2 inches or greater for most of the text. Most signs will be read at about 10 feet (3m) .... but it would be great to be readable at 25 feet (8m)
    1. Reply
    2. 1+ years ago
  • No Comment
    1. Reply
    2. 1+ years ago
  • No Comment
    1. Reply
    2. 1+ years ago
  • No Comment
    1. Reply
    2. 1+ years ago
  • No Comment
    1. Reply
    2. 1+ years ago
  • I like what you did to highlight "Combustion Chamber Kits" and group the High Temp Insulation with its sub components
    1. Reply
    2. 1+ years ago
  • Design #19 - Didn't mean to eliminate this....but see my comment about Design #14
    1. Reply
    2. 1+ years ago
  • I really like what you have done with the "Combustion Chamber Kits" and "High Temperature Insulation" Some suggested changes. Swap the positions of the top and bottom banners. i.e. put "Combustion Chamber Kits" and web address at the top and put the "High Temp Insulation" and "board, paper, etc" at the bottom. Also for the logo and background I prefer what has been done on design #19...that has a glow behind Lynn
    1. Reply
    2. 1+ years ago
  • I really like what you have done with the "Combustion Chamber Kits" and "High Temperature Insulation" Some suggested changes. Swap the positions of the top and bottom banners. i.e. put "Combustion Chamber Kits" and web address at the top and put the "High Temp Insulation" and "board, paper, etc" at the bottom. Also for the logo and background I prefer what has been done on design #19...that has a glow behind Lynn
    1. Reply
    2. 1+ years ago
  • I really like what you have done with the "Combustion Chamber Kits" and "High Temperature Insulation" Some suggested changes. Swap the positions of the top and bottom banners. i.e. put "Combustion Chamber Kits" and web address at the top and put the "High Temp Insulation" and "board, paper, etc" at the bottom. Also for the logo and background I prefer what has been done on design #19...that has a glow behind Lynn
    1. Reply
    2. 1+ years ago
  • Too elaborate
    1. Reply
    2. 1+ years ago
  • Too elaborate
    1. Reply
    2. 1+ years ago
  • Too elaborate
    1. Reply
    2. 1+ years ago
  • Too elaborate
    1. Reply
    2. 1+ years ago
  • Too elaborate
    1. Reply
    2. 1+ years ago
  • Too elaborate
    1. Reply
    2. 1+ years ago
  • Having spoken with the printer - using more than one color will not impact the cost significantly. Having said that we I would like to keep the use of color as subtle....blue, shades of blue, grey....etc
    1. Reply
    2. 1+ years ago
  • Dear Contest Holder, thank you for your very warm responds! :) I apologize for late reply. Here I revised the designs, #15, #16, #17. I keep using a single color for the design #17 . Thank you very much! Best, FeFei
    1. Reply
    2. 1+ years ago
  • Feedback for #12 and #11 See prior post about making "Combustion Chamber Kits" more prominent and grouping the High Temp Insulation with the Board, Blanket etc....
    1. Reply
    2. 1+ years ago